Table of Contents
Advertisement
Adjustment tips for the operating menu
Entering a name – "NAME"
Via the "NAME" menu, you can enter a freely selectable name for the transmitter. This name can
be displayed on the standard display and can consist of up to six characters such as:
•
letters (without pronounciation marks),
•
numbers from 0 to 9,
•
special characters and spaces.
After you have changed to the setting mode of the "NAME" menu, the first segment starts
flashing on the LC display panel
SET
UP
DOWN
Adjusting the microphone sensitivity – "ATTEN"
Via the "ATTEN" menu, you can adjust the transmitter's sensitivity.
RF
AF
dB
22
.
Slide the multi-function switch
(DOWN) to select a character.
(By sliding the switch only once, the display jumps either forwards or
backwards to the next character. If you keep the switch slid, the
display starts cycling continuously.)
Press the multi-function switch
to the next segment.
Have you entered the name completely? Press the multi-function
switch
(switch position
appears on the LC display panel.
The sensitivity is correctly adjusted when the level display for audio
signal "AF"
shows full deflection only during the loudest passages
or when the red LED
The sensitivity can be adjusted in 1-dB steps from + 40 dB to –30 dB.
The bargraph has a resolution of approx. 3 dB per segment with
a display range of 45 dB.
to the position
(switch position SET) to change
SET) to store your setting. "STORED"
lights up brightly.
(UP) or
Advertisement
Table of Contents
