Table of Contents
Advertisement
NAME
Name
RESET
Reset
PILOT
Pilot
Entering a name
Via the "Name" menu, you can enter a freely selectable name for each
transmitter and receiver. You can, for example, enter the name of the
performer for whom the adjustments have been made.
The name can be displayed on the standard display and can consist of up to
six characters (transmitters) and up to ten characters (receiver) such as:
letters (without pronounciation marks),
numbers from 0 to 9,
special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
Press the
SET
button to get into the setting mode of the "Name" menu.
The first segment starts flashing on the display.
With the
/
buttons you can now select a character. By briefly pressing
a button, the display jumps either forwards or backwards to the next
character. If you hold down a button, the display starts cycling
continuously.
Press the
SET
button to change to the next segment and select the next
character.
Have you entered the name completely? Press the
your setting and to return to the previous menu level.
Loading the factory-preset default settings
Via the "Reset" menu, you can load the factory-preset default settings. Only
the selected setting for the pilot tone remains unchanged. After the reset, the
unit is restarted and the standard display is shown on the display panel.
Activating/deactivating the pilot tone transmission or
pilot tone evaluation
Via the "Pilot" menu, you can activate or deactivate the pilot tone
transmission of the transmitters and the pilot tone evaluation of the receiver.
The pilot tone supports the squelch function (Squelch) and protects against
interference due to RF signals from other units. The transmitter adds an
inaudible signal, known as the pilot tone, to the transmitted signal. The
receiver detects and evaluates the pilot tone, and is thus able to identify the
signal of the matching transmitter and mute all others.
Transmitters of the ew 300 series (first generation) do not transmit a pilot
tone and the receiver of the ew 300 series (first generation) cannot evaluate
the pilot tone. Nevertheless, you can combine units of the ew 300 series (first
generation) with units of the ew 300 G2 series (second generation).
However, when combining units, please observe the following:
With an ew 300 G2 transmitter and the ew 300 G2 receiver:
Activate the pilot tone function with both transmitter and receiver.
With an ew 300 transmitter and the ew 300 G2 receiver or vice versa:
Deactivate the pilot tone function with the ew 300 G2 transmitter or recei-
ver.
SET
button to store
79
Hide quick links:
Advertisement
Table of Contents
