Table of Contents
Advertisement
Adjustment tips for the operating menu
Entering a name – "NAME"
Via the "NAME" menu, you can enter a freely selectable name for the transmitter. This name can
be displayed on the standard display and can consist of up to six characters such as:
•
letters (without pronounciation marks),
•
numbers from 0 to 9,
•
special characters and spaces.
After you have changed to the setting mode of the "NAME" menu, the first segment starts
flashing on the LC display panel ¿.
SET
UP
DOWN
¾
Adjusting the microphone sensitivity – "ATTEN"
Via the "ATTEN" menu, you can adjust the transmitter's sensitivity.
RF
AF
dB
·
22
Slide the multi-function switch
(DOWN) to select a character.
(By sliding the switch only once, the display jumps either forwards or
backwards to the next character. If you keep the switch slid, the
display starts cycling continuously.)
Press the multi-function switch
to the next segment.
Have you entered the name completely? Press the multi-function
¾
switch
(switch position
appears on the LC display panel.
The sensitivity is correctly adjusted when the level display for audio
signal "AF"
shows full deflection only during the loudest passages
·
or when the red LED
The sensitivity can be adjusted in 1-dB steps from + 40 dB to –30 dB.
The bargraph has a resolution of approx. 3 dB per segment with
a display range of 45 dB.
¾
to the position
¾
(switch position SET) to change
SET) to store your setting. "STORED"
lights up brightly.
(UP) or
Advertisement
Table of Contents
