Subscribe to Our Youtube Channel
Related Manuals for Holman 40477T
Summary of Contents for Holman 40477T
- Page 1 Instruction Guide 40477T Holman Rancho Cordova, CA 95742 800-343-7486 InstallationSupport@Holman.com 20231129R2 DATE: ________________...
-
Page 2: Table Of Contents
Oscillating Multi Tool * Sold Separately. Before You Begin • Read all instructions prior to assembling or installing any Holman product. • Always locate your installation locations prior to performing any work. • ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE. -
Page 3: Parts List
Instructions – 40477T Parts List Hardware Step 1 – Trim Factory Threshold Some vehicles may be equipped with a plastic threshold by the sliding door, this needs to be either removed or trimmed before installing the Holman threshold. • Remove plastic plugs from 4 locations circled. -
Page 4: Step 2 - Mark Holes For Door Threshold
Instructions – 40477T Step 2 – Mark Holes For Door Threshold • Place slider threshold into doorway of van. Be sure to have the flanges in the down position. • While applying firm pressure against threshold, mark the four holes onto the floor or floor mat. -
Page 5: Step 4 - Install Door Threshold
Instructions – 40477T Step 4 – Install Door Threshold • Place threshold back into van on top of previously installed plus nuts. • Using four 1/4" x 2” flat head screws, bolt threshold to floor. Step 5 – Mark Holes For Rear Threshold •... -
Page 6: Step 6 - Install Rear Threshold
Instructions – 40477T Step 6 – Install Rear Threshold • Place threshold back into van, on top of previously installed plus nuts. • Using five 1/4" x 2” flat head screws, bolt threshold to floor. Step 7 – Install Rubber Plug •...
Need help?
Do you have a question about the 40477T and is the answer not in the manual?
Questions and answers