SMC Networks LE2FS Series Operation Manual page 13

【Storage】
Warning
① Do not store the product in a place in direct contact with rain or water drops or is
exposed to harmful gas or liquid.
② Store in an area that is shaded from direct sunlight and has a temperature and humidity
within the specified range (-10°C to 60°C and 35% to 85% no condensation or freezing).
③ Do not apply vibration or impact to the product during storage.
■
Maintenance
Warning
① Do not disassemble or repair the product.
Fire or electric shock can result. Contact SMC, in case of disassembly for the maintenance.
② Before modifying or checking the wiring, the voltage should be checked with a tester 5
minutes after the power supply is turned off.
Electric shock can result.
③ Install the electric actuator and its peripheral devices on a fire-proof material.
Direct installation on or near a flammable material may cause a fire.
④ Do not install the product in a place subject to vibrations and impacts.
It will cause failure or malfunction.
⑤ Take measure so that the operating temperature of this electric actuator and its
peripheral devices are within the range of the specifications. Also, this electric actuator
should be installed with 50mm or more between each side of it and other structures or
components.
It may cause a malfunction of the controller and its peripheral devices or a fire.
⑥ Do not mount the electric actuator and its peripheral devices near a large
electromagnetic contactor or no-fuse breaker which generates vibration on the same
panel. Mount them on different panels or keep the electric actuator and its peripheral
devices away from such a vibration source.
⑦ Install the electric actuator and its peripheral devices on a flat surface.
If the mounting surface is distorted or uneven, an unacceptable force may be added to the case,
etc., causing problems.
Caution
① Maintenance should be performed according to the procedure indicated in the
Operation Manual.
Incorrect handling can cause an injury, damage or malfunction of equipment and machinery.
② Removal of product
When equipment is serviced, first confirm that measures are in place to prevent dropping of work
pieces and run-away of equipment, etc., and then cut the power supply to the system. When
machinery is restarted, check that operation is normal with actuators in the proper positions.
- 12 -