Table of Contents
Advertisement
3. TRACTOR REQUIREMENTS
The tractor used to operate the implement must have the power capacity to lift, pull, and operate the Power
Take Off (PTO) at the implement's rated speed while traveling at a ground speed between 2 and 5 MPH.
Operating the implement with a tractor that does not meet the following requirements may cause tractor or
implement damage and be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ........................ Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower............................. 30 HP minimum
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS), tractor cab, or roll-bar and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003str
Operate this Equipment only with a Tractor equipped with an approved roll-over-
protective system (ROPS). Always wear seat belts. Death or serious injury could
result from falling off the tractor, particularly during a turnover when the operator
could be pinned under the ROPS.
3.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the
unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning
signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO with
the PTO master shield missing or in the raised position. OPS-U- 0004str
3.3 Tractor Horsepower
The horsepower required to operate the rake depends on many factors including type of vegetation to be
raked, terrain condition, operator experience, and condition of the implement and tractor. For most raking
conditions, the ER rakes require a tractor with at least 30 HP. Operating the implement with a tractor that does
not have adequate power may damage the tractor engine.
EWR 08/22
© 2022 Alamo Group Inc.
OPERATION
(SG-7) str
Operation Section 4-5
Advertisement
Table of Contents
