Starting The Tractor; Connecting The Implement To The Tractor - Bush Hog EWR Operator's Manual

5.STARTING THE TRACTOR

The operator must have a complete understanding of the placement, function, and operational use of all tractor
controls before starting the tractor. Review the tractor operator's manual and consult an authorized dealer for
tractor operation instructions if needed.
Essential Tractor Controls:
• Locate the light control switch
• Locate the engine shut off control
• Locate the brake pedals and the clutch
• Locate the PTO control
• Locate the 3-point hitch control lever
• Locate the hydraulic remote control levers
Before starting the tractor ensure the following:
• Conduct all pre-start operation inspection and service according to the tractor operator's manual.
• Make sure all guards, shields, and other safety devices are securely in place.
• The parking brake is on.
• The PTO control lever is disengaged.
• The 3-point hitch control lever is in the lowered position.
• The hydraulic remote control levers are in the neutral position.
• The tractor transmission levers are in park or neutral.
Refer to the tractor owner's manual for tractor starting procedures. Only start the tractor while seated and
belted in the tractor operator's seat. Never bypass the ignition switch by short circuiting the starter solenoid.
After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden and
unexpected tractor movement. OPS-U-0028str
Never run the Tractor engine in a closed building or without adequate ventilation. The exhaust
fumes can be hazardous to your health.
Start tractor only when properly seated in the Tractor seat. Starting a tractor in
gear can result in death or serious injury. Read the Tractor operators manual
for proper starting instructions.

6.CONNECTING THE IMPLEMENT TO THE TRACTOR

Use extreme caution when connecting the implement to the tractor. The implement should be securely resting
at ground level or setting on blocks. Keep hands and feet from under the implement and clear of pinch points
between the tractor hitch arms and implement pins. OPS-U-0038 str
Always shut the Tractor completely down, place the transmission in park, and set the parking
brake before you or anyone else attempts to connect or disconnect the Implement and Tractor
hitches.
EWR 08/22
© 2022 Alamo Group Inc.
OPERATION
(SG-13) str
(S3PT-15) str
Operation Section 4-7
(SG-23) str