Specifications; Operation; Attachment; Detaching From Tractor - Bush Hog CLR Operator's Manual

SPECIFICATIONS

LRC 48
Rake Width
HItch Type Category I
Tractor HP 24 (Maximum)
Rake Pivot 18° & 36° Frt. & Rr.
Pivot King Pin
Tine Spacing
Tine Size 5/16 x 1"
Weight (lbs.)
Tines
WARNING
DURING RAKE ADJUSTMENT
KEEP BODY, HANDS AND FEET CLEAR
OF RAKE.
KEEP FINGERS CLEAR OF HOLES.

ATTACHMENT

The rake should be placed on level ground.
Place the tractor rockshaft control in "position con-
trol" (non-floating) for attaching and detaching the
rear mounted rake. "Draft control" or "position con-
trol" can be used while operating.
Back the tractor until the ends of the lift arms can be
attached to the lift points on the implement. Secure
the lift arms to the mast. (Figure 1)
LRC 60
48"
Category I
24 (Maximum)
18° & 36° Frt. & Rr.
1"
1"
5/16 x 1"
168
King Pin
SECTION I

OPERATION

60"
1"
1"
178
Index Pin
Attach the center link to the top of the mast and
adjust so that the rake frame will be level in the
operating position.

DETACHING FROM TRACTOR

Lower the rake to the ground with rockshaft control
in position control. Remove top link from mast, dis-
connect hitch arms from bottom pins and pull tractor
away from rake.
WHEN DETACHING THE RAKE, SUPPORT
THE MAST END OF THE BOOM FRAME
TO PREVENT IT FROM FALLING. KEEP
BODY, HANDS AND FEET CLEAR OF
IMPLEMENT.
6
Figure 1 CLR
Mast
Lift pin
Angle Adjusting Holes
CAUTION