Table of Contents
Advertisement
OPERATION
7.3 Hitch
The tractor hitch (35) can be set in different
positions, using holes (36), to allow coupling to all
tractor types. By turning the hitch upside-down
from (A) to (B), additional settings are available.
Adjust hitch so tongue is level.
7.4 Hay Rake Arm
The hay rake arm can be pivoted to obtain a
different working angle and further variation of the
swath. Pin (12) is inserted in the different holes in
quadrant plate (2) and fastened with the clip (3).
The central position is the best for most working
conditions.
7.5 Springs
The springs should normally be attached as
shown in the large illustration and in the detail at
the upper left (attached at the central hole). They
can be attached to the other two holes to be
obtain a different rake wheel pressure on the
ground.
EWR 08/22
Operation Section 4-9
© 2022 Alamo Group Inc.
Advertisement
Table of Contents
