Table of Contents
Advertisement
3. TRACTOR REQUIREMENTS
The tractor used to operate the implement must have the power capacity to lift, pull, and operate the Power
Take Off (PTO) at the implement's rated speed while traveling at a ground speed between 2 and 5 MPH.
Operating the implement with a tractor that does not meet the following requirements may cause tractor or
implement damage and be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt
•
Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting, PTO Master Shield
•
Tractor Horsepower - Minimum........BSR8 - 30HP, BSR10 - 30HP, BSR12 - 50HP
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
3.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement.
with the PTO master shield missing or in the raised position. OPS-U- 0004
3.3 Tractor Horsepower
The power required to operate these implements is determined by the tractor PTO horsepower. For most
operating conditions, the RHP8 and RHP10 rake requires a tractor with at least 30 HP, and the RHP12 rake
requires a tractor with at least 50 HP. Operating these implements with a tractor that does not have adequate
power may damage the tractor engine.
BSR Series Rakes 03/14
© 2014 Alamo Group Inc.
OPERATION
Operation Section 4-5
(SG-7)
Never operate the tractor PTO
Advertisement
Table of Contents
