Table of Contents
Advertisement
TEST MODE (SWI-7)
The CycleFlo has a built-in test program that allows for dynamic testing of all internal and external components.
Once activated, the self-test mode will do the following continuously until the test mode is de-activated:
• All display digits count from 0-9 in unison. This is used to determine any of the displays are faulty.
Replace the display board If segments of the display fail to activate during the self test.
• Each of the 5 front panel buttons activates a decimal point on the LED displays. Replace the
display board if a button fails to activate a decimal point.
Position SW1-7 to the ON position to activate the self-test mode. Position SW1-7 to the OFF position to de-
activate the self-test mode.
REMOTE RUN TEST (SWI-8)
Position SWI-8 (the REMOTE RUN test) to the ON position to activate the AIR SUPPLY VALVE signal and cycle
the solenoid valves at the CPM rate set by SW1-1,2,3,4. The Remote Run Test (SWI-8) performs the same
function as closing the Remote Run Switch input, and therefore is used to test the functionality of the Remote Run
Switch input. Follow the trouble shooting guide on page 11 if either fails to operate.
12
Self-Test Mode
During this test the solenoid valves
may be activated.This will activate a
connected pump. To prevent
inadvertent pumping, disconnect the
air supply to the solenoid valves or
remove the air lines to the pump.
309003
Advertisement
Table of Contents
