Operation; Run Mode; Test Mode - Graco 24W482 Instructions Manual

Operation

Run Mode

The controller is in Run Mode providing the following cir-
cumstances are present:
• The controller is not in SETUP MODE.
• An Alarm is not active.
Timer Mode: Pump ON
The display indicates the amount of time remaining in
the pump cycle, counting down the Pump ON time value
(see Time Control (on:ti) ON Setup, page 7).
• The Pump output is enabled.
• Pump ON time is shown in MM:SS (minutes:sec-
onds).
Timer Mode: Pump OFF
The display indicates the amount of time remaining in
the pump OFF cycle, counting down the Pump OFF time
value (see Programming OFF Time Duration, page 8).
• The Time OFF LED illuminates and the pump output
is disabled during the Pump OFF time.
• Pump OFF time is shown in HH:MM (hours:minutes)
or MM:SS if the time remaining is less than an hour.
334662B

Test Mode

To enter Test Mode:
1. Press the LEFT and
RIGHT ARROW
buttons together for
3 seconds.
2. The unit will cycle ON for 45 seconds and OFF for
15 seconds until the Test Mode is exited.
3. To exit Test Mode, press the Reset
button once.
Setup
9