Installation; Verifying The Shipment And The Contents; Items Supplied; Required Tools - Danfoss iC7 Series Operating Manual

Operating Guide | Voltage Measurement Option OC7V0

Installation

5

Verifying the Shipment and the Contents

5.1
Make sure that the items supplied and the information on the product label correspond to the order confirmation. The product label is
placed on the front and right side of the option casing.
Figure 3: Example of a Product Label
1
Product name
3
Serial number
5
Identification of I/O connections on the option

Items Supplied

5.2
The Voltage Measurement Option OC7V0 can be ordered as a separate option for field mounting by using the code number.
When the Voltage Measurement Option OC7V0 is not mounted at the factory, the following items are included in the shipment:
Voltage Measurement Option OC7V0
l
DIN rail 35 x 7.5 x 150 mm (1.38 x 0.30 x 5.91 in)
l
LC/LC duplex multimode patch cable, length: 5 m (16 ft)
l
Option Extender OC7F2
l
Option connector
l

Required Tools

5.3
The required tools for the installation are:
Flathead screwdriver (the recommended size of the head is 0.3 x 2.5 mm)
l
Torx screwdriver (size TX20)
l
Wire crimper
l

Installing Boards to the Modular Control Unit

5.4
DAMAGE TO OPTION BOARDS
Do not install, remove, or replace option boards on the drive when the power is on. Doing this can cause damage to the boards.
Switch off the AC drive before installing, removing, or replacing option boards on the drive.
l
8
| Danfoss A/S © 2024.01
2
Code number
4
2D code which can be used to access detailed product
information via MyDrive® tools
6
Compliance and approval markings
NOTICE
AQ476649821259en-000101 / 136R0332