Configuration; Configuration Overview; Option Slot Addressing In Systems With Modular Control Unit - Danfoss iC7 Series Operating Manual

Operating Guide | Voltage Measurement Option OC7V0

Configuration

4

Configuration Overview

4.1
The parameters related to Voltage Measurement Option OC7V0 are in parameter group 9, called Option Board Settings. Parameters
depend on the mounting and will appear in the parameter menu after the functional extension has been mounted and wired.

Option Slot Addressing in Systems with Modular Control Unit

4.2
The physical slots 1 and 2 on the modular control unit are reserved for default control unit components. Functional extension options are
positioned in the physical slots A–H as shown in
When referred to in the software, the option uses a different name for the software address. The 1st slot position with an installed option
is always addressed as 201, the 2nd position as 202, and so on, regardless of which option slot the 1st option is installed in. Software
address 101 is reserved for default control unit components.
Table 2: Physical Option Slot and Its Software Address in Systems with Modular Control Unit
Software address
101
Slot
1
Figure 2: Option Slot Locations in Systems with Modular Control Unit
Danfoss A/S © 2024.01
Figure 2.
101 201 202
2 A B
203 204 205
C D E
AQ476649821259en-000101 / 136R0332 |
206 207 208
F G H
7