Mounting The Controller; Plastic Cabinet Wall Mounting - Hunter ICC2 Owner's Manual

Mounting the Controller

PLASTIC CABINET WALL MOUNTING

1. Remove the door and control panel for easier access.
Use the enclosed hole template to mark and drill
mounting holes. Be sure to leave enough room to open
the door. Install screw anchors if attaching to drywall or
masonry wall.
2. Secure a 25 mm screw into the wall, leaving 6 mm free
of the wall. Slide the top centre keyhole on the rear of
the controller over the screw and hang the cabinet on
the screw head.
3. Drill four pilot holes for the remaining mounting screws.
4.
Secure the controller in place by installing screws in the
four remaining holes from inside the cabinet. Reattach
the control panel and the door.
Wall Mounting, plastic box.2
8
Wall Mounting
Wall Mounting, plastic box.2
hunter.help/ICC2EM