Pro-Hc - Mounting Controller; Installing The Pro-Hc Controller; Mounting The Controller To A Wall - Hunter Hydrawise PRO-HC Owner's Manual

SENSOR WIRE
Normally Open/Normally Closed wire
Second (common) wire
See Configuring Sensors

PRO-HC - Mounting Controller

INSTALLING THE PRO-HC CONTROLLER

Start by choosing a location with good Wi-Fi coverage. Wi-Fi coverage can be easily tested
using a smartphone. A high signal strength is recommended. Wi-Fi connectivity can also
be tested on the Pro-HC itself (signal strength is shown when you select a wireless
network).

MOUNTING THE CONTROLLER TO A WALL

All necessary hardware is included for most installations.
1. Use the hole at the top of the controller as a reference and secure a 1" (25 mm) screw
into the wall. Note: Install screw anchors when attaching the controller to drywall or
masonry wall.
2. Align controller with the screw and slide the keyhole on top of the controller over the
screw.
3. Secure controller in place by installing screws in the other mounting holes.
STEPS 1-3
for full instructions on setting up sensors.
[1]
Copyright 2020 Hunter Industries. All Rights Reserved.
LABEL ON CONTROLLER
SEN-1, SEN-2
SEN COM
4