Mounting The Controller To A Wall - Hunter PRO-C PC Series Owner's Manual And Installation Instructions

MOUNTING THE CONTROLLER TO A WALL

All necessary hardware is included for most installations.
1. Use the hole at the top of the controller as a reference and
secure a 1" (25 mm) screw into the wall. Note: Install screw
anchors if attaching to drywall or masonry wall.
2. Align controller with the screw and slide the keyhole
on top of the controller over the screw.
3. Secure controller in place by installing screws in the holes.
For PC-401-A: If the supply cord is damaged, it must be
replaced by the manufacturer or service agent or a similarly
qualified person to avoid hazard.
NOTE: The indoor Pro-C is not weather-
or water-resistant, and must be installed
indoors or in a protected area. This device
is not intended for use by young children.
Never let children play with this device.
The outdoor model is water- and weather-
resistant. Connecting the outdoor Pro-C
to the primary power should be done by
a licensed electrician following all local
codes. Improper installation could result
in shock or fire hazard. This device is not
intended for use by young children. Never
let children play with this device.
8