Programming The Controller; Setting Current Date And Time; Setting Program Start Times - Hunter ICC2 Owner's Manual

SETTING CURRENT DATE AND TIME

1. Turn the dial to the Date/Time position.
2. The current year will flash. Use the
to change the year. Press the
setting the month.
3. The month will flash. Use the
the month. Press the ►
day.
4. The day will flash. Use the
the day of the month. Press the
setting the time.
5. The time will display, and the time period will flash. Use
the + and – buttons to select AM, PM, or 24-hour mode.
6. Press the ► button to move to hours. Use the
buttons to change the hour.
7. Press the ► button to move to minutes. Use the
buttons to change the minutes.

SETTING PROGRAM START TIMES

1. Turn the dial to the Start Times position.
2. Press the PRG button to select A, B, C, or D.
3.
The start time will flash. Use the
change the start time. Start times advance in 15-minute
increments.
4. Press the ► button to add another start time or the
PRG button to set a start time for the next program.
Note: The controller has eight start times available per
program, and it can run any two programs at once.
5. To eliminate a Program Start Time: With the dial set to
the Start Times position, push the
you reach 12:00 AM (midnight). Press the
to reach the "OFF" position.
Built on Innovation
®
+ and – buttons
►
button to proceed to
+ and – buttons to change
button to proceed to setting the
+ and – buttons to change
► button to proceed to
+ and
+
+ –
and buttons to
+ and – buttons until
–
button once

Programming the Controller

System O
Manual
Solar Sync
Seasonal Adjust
–
and –
System O
Manual
Solar Sync
Seasonal Adjust
®
®
RAIN SENSOR Active Bypass
Date/Time
Start Times
Run Times
Water Days
RAIN SENSOR Active Bypass
Date/Time
Start Times
Run Times
Water Days
23