Hc - Controller Mounting; Cable Entry; Entry From The Rear Of The Controller; Entry Via ¾ Inch Conduit - Hunter Hydrawise HC Owner's Manual

HC - Controller Mounting

The HC is designed for indoor installations only. The chosen location must have Wi-Fi
coverage. Wi-Fi coverage can be easily tested using a smart phone with Wi-Fi connectivity
or on the HC itself (signal strength is shown when you select a wireless network).
Note: The HC Controller is an indoor model and is not water-proof or weather resistant,
and must be installed indoors or in a protected area. Do not plug transformer into power
source until controller is mounted and all wiring has been connected.

CABLE ENTRY

The controller has 2 cable entry options -- from the rear of the case or via a conduit from
the bottom of the controller.

ENTRY FROM THE REAR OF THE CONTROLLER

Using a sharp knife, remove the 2 cutouts on the rear of the controller as indicated on the
diagram as .
ENTRY VIA ¾ INCH CONDUIT
Using a sharp knife, cut around the semi-circular line on the controller as indicated on the
diagrams as . Cut around the matching line on the blue controller wiring cover.

MOUNTING THE CONTROLLER

1. Using a drill bit of 3/16 inch diameter, drill a hole to a depth of 1 inch (25 mm).
2. Insert plastic anchor so it is flush with the surface of the wall.
3. Screw 1 inch screw into plastic anchor leaving the head protruding about 1/8 inch (4
mm).
4. Slide the controller case over the screw head.
Copyright 2020 Hunter Industries. All Rights Reserved. 8