Setting Solar Sync; Manual Operation Of A Single Station - Hunter ICC2 Owner's Manual

SETTING SOLAR SYNC

Add an optional Solar Sync Sensor (wired or wireless) for
automatic Seasonal Adjustment based on daily weather
conditions on-site.
1. Turn the dial to the Solar Sync position.
2. The Region setting will blink. Press the
to select Region 1–4. For accurate Solar Sync
measurements, the Region must be programmed for
the typical peak ET for your area (see the Solar Sync
Owner's Manual).
3. Press the ► button to select the Water Adjustment
+ –
value. Press the or buttons to increase or decrease
Water Adjustment from 1–10. The default setting is 5
and is recommended to remain at 5 after installation.
However, if the Seasonal Adjustment appears to be
changing too much or too little, the Water Adjustment
value can be modified. Scan below to access the online
Solar Sync support section.
SCAN
for help
hunter.help/SolarSync

MANUAL OPERATION OF A SINGLE STATION

1. Turn the dial to the Manual position.
2.
Station run time will flash in the display. Press the
button to advance to the desired station.
3. Press the + and – buttons to select run time duration
from 1 minute to 12 hours.
4. Turn the dial to the Run position, and the station will
begin watering. Only the designated station will water
for its specified duration. Once completed, the controller
will return to automatic run mode with no changes in the
previously set program.
Note: Manual Single Station function ignores any attached
sensor and will allow watering to occur. Do not use Manual
Single Station to test a rain sensor. Use Run Program and
One-Touch Manual Start instead.
Built on Innovation
®
+ or – buttons
►
Programming the Controller
System O
Manual
Solar Sync
®
Seasonal Adjust
System O
Manual
Solar Sync
®
Seasonal Adjust
RAIN SENSOR Active Bypass
Date/Time
Start Times
Run Times
Water Days
RAIN SENSOR Active Bypass
Date/Time
Start Times
Run Times
Water Days
27