Programming The Controller; Setting The Date And Time - Hunter X-Core XC-801i-E Owners Manual And Programming Instructions

PROGRAMMING THE CONTROLLER

The X-Core display shows the time and day when the controller is idle.
The display changes when the dial is rotated to indicate the specific
programming information to enter. When programming, the flashing
portion of the display can be changed by pressing the
To change something that is not flashing, press the
the desired field is flashing.
Three programs A, B, and C, each with the ability to have four daily
start times, permit plants with different watering requirements to be
separated on different day schedules.

Setting the Date and Time

1. Turn the dial to the CURRENT TIME/DAY position.
2. The current year will be flashing. Use the
the year. After setting the year, press the
setting the month.
3. The month and day will be in the display. The month will be flash-
ing and the icon will be displayed. Use the
change the month. Press the
4. The day will be flashing and the
or buttons to change the day. Press the
to setting the time.
5. The time will be displayed. Use the
PM, or 24 hour. Press the
flashing. Use the and
the display. Press the button to move to minute. Minutes will be
flashing. Use the and
the display. The date, day, and time have now been set.
or
or buttons until
or buttons to change
button to proceed to
or buttons to
button to proceed to setting the day.
icon will be displayed. Use the
button to proceed
and buttons to select AM,
button to move to hours. Hours will be
buttons to change the hour shown on
buttons to change the minutes shown on
NOTE: A basic programming rule is that whatever
symbol or character is flashing will be the item pro-
grammed. For instance, if the hour is flashing when set-
buttons.
ting the time, the hour can be changed or programmed.
For illustration purposes in this manual, flashing char-
acters are in GRAY type.
CURRENT TIME/DAY CURRENT TIME/DAY
17