Setting Of Internal Switches .0 - Sony CCU-D50 Service Manual

1-4. Setting of Internal Switches
1-4. Setting of Internal Switches
PR-270/270A Board
PR-270/270A BOARD (A SIDE)
$1 Reh/AUX_TX AUX RS-232C communicating function setting Rech
Reh: Outputs the R-Y/R/C signal supplied to the
CAMERA connector from R-Y/R/C connector.
(At normal use)
AUX_TX: In the SDI mode, outputs the RS-232C signal
supplied to the CAMERA connector from
INTERCOM/TALLY/AUX connector. (At AUX
RS-232C communicating function use)
S2 Gch/AUX_RX AUX RS-232C communicating function setting Gch
Gch: Outputs the Y/G/Y signal supplied to the CAMERA
connector from Y/G/Y connector. (At normal use)
AUX_Rx: In the SDI mode, outputs the RS-232C signal
supplied to the INTERCOM/TALLY/AUX connector
from CAMERA connector. (At AUX RS-232C
communicating function use)
$1001 RTS 200 OHM Turns ON/OFF 200 Q termination when the external OFF
INTERCOM_RTS system is used.
$2001 ROM WRITE SW RCP: At normal use RCP
ROM WRITE: Select when the software upgrading is executed.
$2004-4 MAINTENANCE mode Turns ON/OFF the software version display. OFF
IF-879 Board
For the settings of S101 (System setting switch) and S102 (Intercom setting switches) on the IF-879
board, refer to the Operating Instructions of this unit.