Inseego Wavemaker PRO FG2000e User Manual page 78

NOTE:
When IP Passthrough is turned on, port forwarding capabilities are set through the connected
host routing system. Settings on this page are not available. Go to Advanced > LAN > IPPT to turn IP
Passthrough off.
Port Forwarding
To turn on port forwarding, move the ON/OFF slider to ON.
To turn off port forwarding, so that no inbound traffic is forwarded to a LAN client, move the slider to
OFF.
Applications
Check the box next to each Port Forwarding application that you want to allow.
To forward all inbound WAN traffic on a specific port to a single LAN client, enter the IP address of the
target device in the Application IP Address field.
Click Save changes.
The following table provides port numbers and protocol information for each port forwarding
application listed.
Application Name
DNS
FTP control (command)
FTP data transfer
HTTP
HTTPS
NNTP
POP3
POP3S
SMTP
SecureSMTP
SNMP
Telnet
TFTP
Yes indicates the protocol is standardized for the port number.
*
No indicates the protocol is standardized for the port number.
Assigned indicates the port number is assigned by IANA (Internet Assigned Numbers Authority) for protocol use, but
may not be standardized.
5G INDOOR ROUTER FG2000e USER GUIDE
Port TCP STCP
*
53 Yes No
21 Yes Yes
20 Yes Yes
80 Yes Yes
443 Yes Yes
119 Yes No
110 Yes No
995 Yes No
25 Yes No
465 Yes No
161 Assigned No
23 Yes No
69 Assigned No
UDP
* *
Yes
Assigned
Assigned
Assigned
Assigned
Assigned
Assigned
Yes
Assigned
No
Yes
Assigned
Yes
78