Inseego Wavemaker PRO FG2000e User Manual page 25

Wi-Fi Protected Setup (WPS) allows compatible devices to connect to a Wi-Fi network without having
to manually enter the password. To enable WPS, turn the Enable WPS slider to on and check the box
next to the networks on which you want to allow WPS.
Band Selection
Each network can be accessed over two bands: 2.4 GHz and 5 GHz:
• The 2.4 GHz band is supported by all devices with Wi-Fi and should be used by devices that are
a few years old or older. This band passes through walls better and propagates over longer
distances, so it may have a longer range.
•
The 5 GHz band is best for newer devices. It offers better throughput, reduced interference and
faster data speeds, but does not pass through walls as well as the 2.4 GHz band.
NOTE:
The guest network must be assigned at least one band before it can be turned on.
2.4 GHz Band Settings
This section displays the 802.11 Mode in use when the 2.4 GHz band is active and allows you to select
a Channel.
NOTE: Leave the Channel set to Automatic unless you need to choose a particular channel for your
environment.
5 GHz Band Settings
This section displays the 802.11 Mode in use when the 5 GHz band is active and allows you to select a
Bandwidth and Channel.
Bandwidth: Leave bandwidth at the default setting unless you experience interference with other Wi-
Fi devices. If you experience interference, try lowering the setting to reduce the interference.
NOTE: Leave the Channel set to Automatic unless you need to choose a particular channel for your
environment.
Select Save changes to store new settings.
5G INDOOR ROUTER FG2000e USER GUIDE 25