Graco ME5 Instructions Manual page 15

Keypad Buttons (F
IG
AUTO
F . 21
IG
• Manual / Reset*
Used to select Manual Mode dispensing (see
Terms). The first push selects the mode, and the
second push resets the display to zero.
• Auto / Reset*
Used to select Auto Mode dispensing (see Terms).
The first push selects the mode, and the second
push resets the display to zero.
* Press Manual / Reset and
Auto / Reset buttons simul-
taneously to display the
Setup Menus (page 15).
• Total
Used in any mode to see the
resettable total and the non–resettable total.
• 10, 1.0, and 0.1
Used in Auto Mode and during setup to enter dis-
pense amounts.
All buttons are disabled while fluid is being dis-
pensed.
312668B
. 21)
PTS QTS
GAL
LITERS
R-TOTAL
ti12052a
PE5 Meter Setup and Operation Instructions
Setup Menus (F
AUTO
F . 22
IG
1. If the display is blank (asleep),
wake it up by pressing any
button on the keypad.
2. Press and hold the Man-
ual/Reset and Total/Reset
buttons simultaneously for
approximately 6 seconds to
enter the Setup Menus .
During the first 4 seconds all segments display.
Then for 2 seconds the software version number
displays.
3. There are five (5) Setup Menu screens available,
stored in a preset order.
a. The first screen displayed is the Resettable
Total Menu (F . 23, page 16). When the menu
IG
is displayed, R-TOTAL (G) will blink in the lower
right corner on the screen.
b. Press and hold the Auto /
Reset button to display
the Units of Measure
Menu (F . 24, page 17).
IG
When this menu is dis-
played the last set Unit of
Measurement blinks in
the lower right corner on the screen.
. 22)
IG
PTS QTS
GAL
LITERS
R-TOTAL
ti12053a
15