Ingenico AXIUM DX6000 User Manual page 16

Direct contact with <<diazo>>papers.
Direct contact with water.
Rubbing or pressing the paper too strongly.
WARNING
For best product performance, only use heat sensitized paper approved by Ingenico.
4.4.2 Installing paper roll
Open the paper cover by lifting the catch located at the top of AXIUM DX6000 and pull the cover to the
rear of the terminal.
Insert the paper roll in the compartment following the directions shown on the below picture.
Pull the paper up to the top of terminal, maintain the paper and close the cover.
Press simultaneously on both upper corners of the paper flap until it clips into position.
ADVICE
If you insert a new R40 paper roll, tear off the first length (one complete turn to avoid printing
on adhesive footprint).
AXIUM DX6000
02/21
16
Banks and Acquirers International Holding SAS
Copyright©2024 Ingenico–
All rights reserved