Furuno TZtouchXL TZT22X Installation Manual page 30

3. HOW TO SET UP THE EQUIPMENT
Menu item
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
[Radar Optimization]
[ARPA Advanced Set-
tings]
[TX Channel]
[Target Analyzer Mode]
[Auto Acquire by Doppler]
[Reset Default Page Set-
tings]
3-12
Description
Select a display in the dual range display to
manually tune.
Not available (grayed out) with DRS2D-
NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
Manually tune the radar.
Not available (grayed out) with DRS2D-
NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
Display various information regarding the connected radar.
Automatically adjust magnetron output and tuning for the connected ra-
dar. Available when the [TX/STBY] setting is [ON]. Do not change these
settings.
Not available with DRS2D-NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
Note 1: For service technicians only.
Note 2: Use this function whenever the magnetron is replaced.
For service technicians only. Do not change these settings.
This item is available when [TX/STBY] is [ON].
Not available (grayed out) with FAR-2xx8 series, FAR-2xx7 series, and
FAR-15x8 series radar antennas.
Select [1], [2] or [3], the channel where the
interference is smallest. See the operator's
manual for details.
Available with DRS2D-NXT/DRS4D-NXT/
DRS6A-NXT/DRS12A-NXT/DRS25A-NXT.
You can emphasize rain clutter or target
echoes when the target analyzer is active.
Select [Rain] or [Target] as appropriate. See
the operator's manual for details. Available
with DRS2D-NXT, DRS4D-NXT, DRS6A-
NXT and DRS12A-NXT.
When set to [ON], approaching targets
(ships, rain clutter, etc.) within 3 NM from
own ship are automatically acquired by the
Doppler calculated from the radar echo.
See the operator's manual for details. Avail-
able with DRS2D-NXT, DRS4D-NXT,
DRS6A-NXT and DRS12A-NXT.
Resets [Radar] menu settings to default.
Options (setting range)
[Range1], [Range2]
[-50] to [50]
[Auto], [1], [2], [3]
[Rain], [Target]
[ON], [OFF]
[OK], [Cancel]