Furuno TZtouchXL TZT22X Installation Manual page 27

Menu Item
[Maximum Wind Speed]
Menu Item
[Minimum Depth]
[Maximum Depth]
[Graphic Instruments Setup] - [Sea Surface Temperature]
Menu Item
[Minimum Sea Surface
Temperature]
[Maximum Sea Surface
Temperature]
[Graphic Instruments Setup] - [Propulsion Engine] or [Other Engine]
Menu Item
[Max. RPM]
[Red Zone Oil Pressure]
[Max. Oil Pressure]
[Min. Temperature]
[Red Zone Temperature]
Menu item
[Add Default CZone
Pages]
[CZone DIP Switch
Settings]
Menu item
[Reset Instrument Pag-
es]
[Reset Default Set-
tings]
[Engine & Tank Automatic Setup] section
The TZT22X/24X will automatically detect engines and tanks connected to the same
network.
This is the recommended method for setting up engines and tanks.
Description
Set the transducer's maximum detectable
speed.
[Graphic Instruments Setup] - [Depth]
Description
Set the transducer's minimum detectable
depth.
Set the transducer's maximum detectable
depth.
Description
Set the transducer's minimum detectable
temperature.
Set the transducer's maximum detectable
temperature.
Description
Set the maximum rpm of your engine to
show on the RPM display.
Set the starting value for the red zone area
of the oil pressure meter.
Set the maximum oil pressure of your
engine.
Set the minimum temperature for your
engine.
Set the starting value for the red zone area
of the engine temperature indicator.
[Graphic Instruments Setup]-[CZone Setup]
Create, edit C-Zone pages.
Set this unit's DIP switches. For the service technician. Do not change the
settings.
Resets all instrument pages to default.
Resets applicable settings to default.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
1 (kn) to 99 (kn)
Options (setting range)
1 (m) to 1999 (m)
1 (m) to 2000 (m)
Options (setting range)
0.00°C to 98.99°C
0.01°C to 99.99°C
Options (setting range)
1 (rpm) to 20,000 (rpm)
0 (psi) to 143 (psi)
1 (psi) to 144 (psi)
0.00°C to 99.00°C
0.01°C to 999.00°C
Description
Description
[OK], [Cancel]
[OK], [Cancel]
3-9