Siemens SIMATIC ET 200SP Equipment Manual page 39

Residual current for signal state "0"
NOTE
Residual current for signal state "0"
Due to the Diagnostics: Wire break function, there is a low level of residual current at an
activated check for wire break in the "0" signal state at the output. This may cause the display
diodes to flicker.
You can minimize this residual current with the "Check for wire break" parameter.
Derating trend
The figure below shows the load current derating with horizontal and vertical mounting
positions. You can use this diagram to determine the maximum total current of the module.
Figure 7-1 Load current to temperature in different mounting positions
If one channel drives a cyclically switched inductive load, this channel contributes 500 mA to
the total current.
Digital output module DQ 16x24VDC/0.5A HF (6ES7132-6BH00-0CA0)
Equipment Manual, 01/2024, A5E52818470-AA
Technical specifications
7.1 Technical specifications
39