Lincoln Electric SAF-FRO DIGISTEEL 385C PRO Operator's Manual page 29

Restore Factory Settings
Note: After Factory Settings restore, the
settings stored in user memory are deleted.
To restore Factory Settings:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Restore
Factory Settings icon.
Figure 56.

Press the Right Knob [36]. The Restore Factory
Settings Menu is shown on the display.

Use the Right Knob [36] to highlight the Check Mark.
Figure 57.

Confirm the select – press the Right Button [36]. The
factory settings are restored.
Diagnostic Information
Available information:

Software Version

Hardware Version

Welding Software

Ethernet IP Address

Power Source Protocol

Event Logs

Fatal Logs.
English
Advanced setup
This menu
configuration parameters of the device.
To set the configuration parameters:

Access to the Settings and Configuration Menu.

Use the Right
"configuration menu" icon.

Press the Right Knob [36]. The Configuration Menu
is shown on the display.

Use the Right Knob [36] to highlight the Parameter
Number which will be changed, for example P.1 -
allows change
"Metric" = m/min.

Press the Right Knob [36].

Use the Right Knob [36] to highlight the in/min
(English/Imperial).

Confirm the select – press the Right Button [36].
25
enables access
Knob [36] to highlight
Figure 58.
WFS units, factory
Figure 59.
Figure 60.
to the
the
default:
English