Lincoln Electric SAF-FRO DIGISTEEL 385C PRO Operator's Manual page 13

Controls and Operational Features
Front Panel
Figure 1.
1. User Interface Cover. Cover shielding user interface.
U7 User Interface is described in separate chapter.
2. Power Switch ON/OFF (I/O): Controls the input
power to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the
power switch is turned on, the indicator will light up to
indicate the machine is ready to weld.
3. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
4. Positive Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
5. Remote Control Connector Plug: To install Remote
Control Kit. This connector allows connection
Remote Control. See "Accessories" chapter.
6. EURO Socket: For connecting a welding gun (for
GMAW / FCAW process).
7. Quick Connect Coupling: Coolant outlet
(supplies cool coolant to the torch/gun).
8. Quick Connect Coupling: Coolant inlet
(takes warm coolant from torch/gun).
English
Rear panel
10. Wire Liner Entry: Enables installing liner for welding
wire delivered in drum package.
11. Chain: To protect gas bottle.
12. Gas hose.
13. Work Lead.
14. Cover bracket: To install cooler cable holder bracket.
15. Quick Connect Coupling: Coolant inlet
(supplies cool coolant to the torch/gun).
16. Quick Connect Coupling: Coolant outlet
(takes warm coolant from torch/gun).
17. Supply Plug: For CO2
"Accessories" chapter).
18. Power Lead (5m): Connect the supply plug to the
existing input cable that is rated for the machine as
indicated in this manual, and conforms to all
applicable standards. This connection shall be
performed by a qualified person only.
19. Gas Connector: Connection for gas line.
20. Gas Flow Regulator Plug: Gas flow regulator can be
purchased separately (see "Accessories" chapter).
9
Figure 2.
gas heater kit (see
English