Removing/Installing The Seat Post; Removing; Installing - Invacare HMV 300 Owner's Operator And Maintenance Manual

REMOVING/INSTALLING THE SEAT POST

Ensure that the seat post mounting screw is properly engaged and locked. Other-
wise, injury and/or damage may result.
NOTE: Take note of position and orientation of the seat post and seat post mounting screw before

removing.

NOTE: The seat post has three (3) height settings. If a change in seat height is desired refer to
adjusting seat height in this section of the manual.
NOTE: For this procedure, refer to FIGURE 7.2.
REMOVING
1. If necessary, remove the seat. Refer to Removing/Installing the Seat on page 34.
2. Remove the mounting screw, two (2) washers and locknut securing the seat post to the
frame post (FIGURE 7.2).
3. Lift seat post UP and remove from frame post.

INSTALLING

1. Insert the seat post into the frame post and align the frame post mounting hole with
the desired seat post mounting hole. Refer to FIGURE 7.2.
2. Insert mounting screw through both the frame post and the seat post. Install the two
(2) washers and locknut onto mounting screw and securely tighten.
3. If necessary, install the seat. Refer to Removing/Installing the Seat on page 34.
Seat Post
Washer
Mounting Screw
Frame Post
Mounting Screw
NOTE: Seat post on 300 shown. Seat post on
400 installs the same way.
FIGURE 7.2 - REMOVING/INSTALLING THE SEAT POST
Part No. 1118395
WARNING
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting Holes
35
SECTION 7—SEAT
Seat Post
Locknut
Washer
300 and 400