Removing/Installing The Seat Assembly; Removing; Installing; Using The Folding Back Assembly - Invacare Pronto Air Personal Transporter User Manual

5.6 Removing/Installing the Seat Assembly

5.6.1 Removing

1. Disconnect the joystick. Refer to 6.5.2 Disconnecting/Connecting
the Joysticks, page 38.
2. Fold down the seat back. Refer to 5.7 Using the Folding Back
Assembly, page 31.
Lift the seat lever A up to release the seat.
3.
4. While holding the seat lever, lift the rear of the seat assembly
B to tilt the seat assembly up.
WARNING!
– DO NOT use armrests to lift seat, otherwise
injury or damage may occur. Use lifting locations
shown in illustration.
5. Pull seat upward towards the rear of the personal transporter
and remove the seat assembly from the seat post mounting pins.
1171794-C

5.6.2 Installing

1. Place the seat mounting bracket C onto the seat mounting pins
and slide the seat assembly forward until the front seat mounting
pin D engages the front slot in the seat mounting bracket.
Lower the rear of the seat until the rear seat mounting pin E
2.
clicks and locks into the seat mount bracket.
3. Pull the seat assembly up to ensure that it is locked in place.
4. Unfold the back. Refer to 5.7 Using the Folding Back Assembly,
page 31.
5. Connect the joystick. Refer to6.5.2 Disconnecting/Connecting
the Joysticks, page 38.

5.7 Using the Folding Back Assembly

•
To fold the back assembly down, perform the following:
1. Hold both sides of the back and pull up.
2. Push the back forward towards the seat, while maintaining
upward tension on back.
Wheelchair Operation
31