E.;
\.
·
..
· '
Removing the Rails
1
Remove the two screws from the
rear of the rails.
Then, remove the two rails from
the rack.
Notes:
1. Use the tightening rod to loosen
the screws.
2. Your 9332 could have been
shipped with standard type
screws. Use a suitable tool to
loosen the screws.
2
Place the tightening rod in the
holder located on the left side of
the screen.
Note:
The tightening rod is not
shipped with the 9332
if
standard
type screws are used.
3
Remove the two nut clips from the
rear of the rack.
R01 C062·0
R01C057-1
RD1 C077-0