Table of Contents
Advertisement
3
Attach the front of the disk unit to
the rack with the two screws.
Use the tightening rod to tighten
the screws.
Note:
Your 9332 could have been
shipped with standard type screws.
Use a suitable tool to tighten the
screws.
4
Attach the rear of the disk unit to
each rail with the brackets and
screws.
Use the tightening rod to tighten
the screws.
Note:
Your 9332 could have been
shipped with standard type screws.
Use a suitable tool to tighten the
screws.
5
Place the_ tightening rod in its
holder (left side of screen).
Note:
The tightening rod is not
shipped with the 9332
if
standard
type screws are used.
6
Continue with the next procedure.
1-12
Installing
(~')·.
.
·~
.
RD1C019-0
Advertisement
Table of Contents
