10
Install the front portion of the right
rail:
Note:
When you move the rail, the
rear pins may slide out.
• Holding the rail in place, move
the front portion of the rail to
center the marked hole
between the pins. Then, move
the front pins behind the frame
holes.
• Force the rail toward the front
so that all pins are in the holes.
11
Warning: You must attach the
rail with a screw before you con-
tinue. If you do not attach the
rail, it will not hold the system
devices.
Attach the right rail with a screw
at the rear of the rack.
Use the tightening rod to tighten
the screw.
Note:
Your 9332 could have been
shipped with standard type screws.
Use a suitable tool to tighten the
screw.
1-8
Installing
RD1 C071-0