IBM 9332-200 Installing page 16

5
Mark the place on the rear of the
rack where you will install the rails:
Notes:
I. Use the same EIA unit number
that you marked on the front.
2. See the label on the side of the
rack for the location of the EIA
unit.
• On the left side, mark the top
hole of the EIA unit with a
pencil.
• On the
rig~t
side, mark the top
hole of the same EIA unit.
6
Install the two nut clips:
• Go to the rear of the rack.
• On the left side, attach a nut
clip over the EIA unit hole
that you marked.
Note:
Ensure tlzat the threaded
nut is behind the frame as you
face the rear.
• On l:he right side, attach a nut
clip over the other EIA unit
hole that you marked.
1-6
Installing
Label
•
••
tJ
~
\\)
Left
• •••
EIA
Unit
RD1C067-0
\\)
\\)
Right
RD1 C068-0