IBM Ultrastar 9ES Quick Installation Manual

IBM storage products

Quick installation guide

Ultrastar 9ES
SCSI
Models: DDRS-34560
DDRS-39130
Handling precautions
1. Do not cover the breather hole! Covering the
breather hole may result in loss of data.
2. Do not press on the drive! Do not apply any force
to the drive during handling or installation.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic dis-
charge (ESD).
4. Do not open the static-protective bag containing the
drive until required. Static electricity can damage the
drive.
5. Turn off and unplug your computer. Remove cover.
6. When installing the drive, touch a grounded,
unpainted metal surface with the static-protective
package containing the drive for at least two seconds.
(This drains static electricity from the package and
from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save the drive packaging material including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging.
Installation procedure
It is advisable to backup all data before proceeding
with the installation.
This procedure may require use of a bootable System
Diskette containing FDISK.COM and FORMAT.COM.
IBM Hard Disk Drive Technical Support Center
Setting the address
1. Each drive on the SCSI bus must have a unique
address. Fifty pin (narrow SCSI) devices have 8 pos-
sible addresses (0-7) with address 7 (highest priority)
normally reserved for the controller. Sixty-eight and
eighty pin (wide SCSI) devices have 16 possible
addresses (0-15).
2. SCSI address bits 3 (68 & 80 pin only), 2, 1, and 0
of the 12-pin Option Jumper Block are used to select
the SCSI device ID. The shipping default is ID 6 (bits
2 and 1).
Note: SCSI address bit 3 is reserved on the 50-pin models
Ground
23 (1) 24
21 (2) 22
19 (3) 20
17 (4) 18
15 (5) 16
13 (6) 14
11 (7) 12
9 (8) 10
7 (9) 8
5 (10) 6
3 (11) 4
LED Anode
1 (12) 2
Power
Connector
Logic Card
SCSI I/F
Connector
Page 1
Bit 3
Bit 2
Bit 1
Bit 0
Enable Auto Spin Up
Enable SCSI Terminator (50,68 pin)
Disable Unit Attention
Enable TI-SDTR (50-pin)
Enable TI-SDTR/WDTR (68, 80 pin)
Enable Auto Start Delay
Delay Start 6/12
Disable SCSI Parity Check
LED Cathod
Back side of drive
JP1
Option blcok
JP12
version 3.0