Lincoln Electric Cross Country 300 Service Manual page 24

LINCOLN ELECTRIC
Observe Safety Guidelines
detailed in the beginning of this manual.
PROBLEMS
(SYMPTOMS)
The engine will not crank when
the start button is pushed.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact the
Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call 1-888-935-3877.
POSSIBLE AREAS OF
MISADJUSTMENT(S)
ENGINE PROBLEMS
1. Check the circuit breaker
(CB5). Reset if tripped.
2. Make sure the run/stop
switch is in the 'RUN' position.
3. Check for loose or faulty
battery cable connections.
4. The battery may be low or
faulty. If the battery will not
accept a charge, replace it.
CAUTION
Cross Country™ 300 Service Manual
TROUBLESHOOTING GUIDE
RECOMMENDED
COURSE OF ACTION
1. Check the wiring and the
connections at the starter
motor, glow plug button, circuit
breaker (CB5), run/stop switch
and start button. See Wiring
Diagram.
2. Check the chassis ground
connections between the
engine block and the negative
battery terminal.
3. Place the run/stop switch to
the 'Run' position. Press the
start button, while checking for
voltage between a good clean
chassis ground connection (-)
and lead 231 (+) at the starter
solenoid. See Wiring Diagram.
4. If battery voltage is present,
the starter motor or solenoid
may be defective or the engine
may be prevented from turning
due to a mechanical failure.
19