Lincoln Electric Cross Country 300 Service Manual page 109

LINCOLN ELECTRIC
3. Using a 1/2" nutdriver and a 1/2" open-end wrench, attach the bolt, nut, lock washer and two flat
washers securing the choke assembly to the choke bracket.
4. Using a 3/4" nutdriver, attach the bolt, lock washer and flat washer securing the choke lead to the
rear side of the negative CV output terminal. See Wiring Diagram.
5. Using a 3/4" nutdriver, attach the bolt, lock washer and flat washer securing the choke lead to the
rear side of the negative CC output terminal. See Wiring Diagram.
6. Replace any previously removed cable ties.
7. Perform the Field Capacitor Replacement Procedure.
8. Perform the Case Cover Replacement Procedure.
9. Perform the Retest After Repair Procedure.
Figure F.57 – Choke lead connection points
Cross Country™ 300 Service Manual
NEGATIVE (-) CC
OUTPUT TERMINAL
NEGATIVE (-) CV
OUTPUT TERMINAL
104