Operation; Information On Sawing; Inserting And Removing The Battery - Parkside PSSPA 20-Li C3 Original Instructions Manual

GB MT
Charging the battery
1. Plug the charger into a socket.
2. Slide the battery (25) into the charging slot
of the charger.
3. Once charging is complete, disconnect the
charger from the mains supply.
4. Remove the battery from the charger.

Operation

Information on sawing

Selecting a stroke rate
The rotary wheel (1) at the top of the device
has 6 levels for achieving the desired stroke
rate.
Selecting the pendulum motion
The larger the pendulum motion, the faster your
progress.
The optimal pendulum motion can be estab-
lished through practice; the following settings
are recommended:
• For thin material, hard material (e.g. metal)
or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum motion:
Level 0 or 1.
• Soft material (wood, plastic, etc.): Level 2
or 3
The label shows examples on the setting:
0 Metal
1 Plastic pipe
2 Thin wood
3 Thick wood
Plunge sawing
Requirements
• Soft materials such as wood, aerated con-
crete, plasterboard etc.
• Mitre angle: 0°
• Maximum stroke rate selected (level 6)
• Short saw blade mounted
30
Procedure (Fig. F)
1. Place the device with the front edge of the
footplate (11) on the workpiece. The saw
blade (16) does not touch the workpiece.
2. Turn the device on. Wait until the maximum
stroke rate has been reached.
3. Press the saw blade (16) into the workpiece
until the footplate (11) rests on the work-
piece.
4. Continue sawing along the cutting line.
General Information
With this order, you work safely with the sabre
saw and achieve a good result:
1. Clamp the workpiece. Use a clamping
device for small workpieces.
2. Draw a line to specify the direction in which
the saw blade is guided.
3. Hold the device securely by the handle.
4. Set the stroke rate.
5. Set the mitre angle.
6. Set the stroke strength.
7. Turn the device on.
8. Wait until the device has reached its full
stroke rate.
9. Place the footplate on the workpiece.
10. Slowly move the device along the marked
line, pressing the footplate firmly down onto
the workpiece.
11. Do not apply too much pressure in the cut-
ting direction. Let the device do the work.
12. Before shutting down the device, switch it
off and wait for it to come to a complete
standstill.
Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the rechargeable
battery into the device once the device is fully
prepared for use.
NOTICE! Risk of damage! An incorrect battery
can damage the device and battery. An up-to-
date list of battery compatibility can be found
at: www.lidl.de/akku