Graco XM PFP Repair Parts page 15

5. Remove front display panel (507) and gasket (513).
Display Cable
513
506
6. Discard old display assembly.
7. Place new front display panel (507) and
gasket (513) on front panel of control box (16).
NOTE:
To ease installation use clear tape to hold front display
panel in place.
8. Carefully connect display cables and key switch
cable to new circuit board.
9. Install new rear display panel (506) and secure with
four screws (505). Ensure key switch cable pro-
trudes from opening in top of display module.
10. Install access cover and screws. Apply warning
label to access cover.
11. Reconnect CAN cable to display module.
12. Reconnect power.
13. Load software. See Upgrade Software, page 13.
14. Replace shroud.
15. Configure system settings as they were set on old
display. See XM PFP Operation manual for instruc-
tions.
Replace Front Panel
See Replace Display, page 14, for instructions.
3A2989B
539
507
505
Repair
15