Pc Health Status - AMD 780G User Manual

3-10 PC Health Status

This section shows the Status of you CPU, Fan, Warning for overall system status. This is
only available if there is Hardware Monitor onboard.
Show PC Health in Post
Shutdown Temperature
SMART FAN Configuration
Vcc3.3
Vcore
NBVCC
+5V
+12V
5VSB
VDIMM
CPU Temperature
System Temperature
CPUFAN Speed
SYSFAN1 Speed
SYSFAN2 Speed
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Show PC Health in Post
During Enabled, it displays information list below. The choice is either Enabled or Disabled
Shutdown Temperature
This item can let users setting the Shutdown temperature, when CPU temperature over this
setting the system will auto shutdown to protect CPU.
PS CPU Smart FAN Configurations
CPU Full-Speed Temp
This item allows you setting the FAN works in full speed when the temperature over the value
which out set. If the temperature below the value but over the Idle Temperature, the FAN
will works over 60% of full speed, and the higher temperature will gain higher FAN speed,
after over the temperature which this item setting, the FAN works in full speed.
CPU Idle Temp
This item allows you setting the FAN works in 60% of full speed, when the temperature
lower than the temperature which you setting.
CPU Temperature/ System Temperature / NBTemperature /SYSFAN1, FAN2
Speed/Vcore/ Vdd/3.3V/+5V/+12V/-12V/VBAT(V)/5VSB(V)
This will show the CPU/FAN/System voltage chart and FAN Speed.
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Enabled
Disabled
Press Enter
3.44v
1.36V
1.12V
5.16V
12.14V
5.24V
1.95V
38 ° C
27 ° C
2550RPM
0 RPM
0 RPM
F6:Fail-safe Defaults
Menu Level >
F7:Optimized Defaults
33
Item Help