Table of Contents
Advertisement
Yes: Let the operating system configure Plug and Play devices, not required for boot if
your system has a Plug and Play system.
Allocate IRQ for PCI VGA
The optional settings are: No; Yes.
Yes: Assigns IRQ to PCI VGA card if card requests IRQ.
No: Does not assign IRQ to PCI VGA card even card requests an IRQ.
Palette Snooping
The optional settings are: Enabled; Disabled.
Enable: inform the PCI device that an ISA graphics devices is installed in the system
so the card will function correctly.
PCI IDE Bus Master
The optional settings are: Enabled; Disabled.
Enable: BIOS uses PCI busmastering for reading/writing IDE devices.
Offboard PCI/ISA IDE Card
Some PCI IDE cards may require this to be set to the PCI slot number that is holding
the card.
Auto: Works for most PCI IDE cards.
3-10 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status.
This is only available if there is Hardware Monitor onboard.
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
PC Health Status
Smart FAN Configuration
H/W Health Function
CPU Temperature:
System Temperature:
CPUFAN Speed:
SYSFAN1 Speed:
SYSFAN2 Speed:
VLDT
VDIMM
Vcore
VNB
↑↓ : Move
Enter: Select
F5: Discard Charges
H/W Health Function,
It displays information list below when set as below. The choice is either Enabled or
Disabled.
CPU
Temperature/
Speed/SYSFAN2 Speed/VLDT/VDIMM/VCore/VNB
This will show the CPU/ /System voltage chart and FAN Speed, etc.
PC Health Status
Press Enter
Enabled
59°C/138°F
40°C/104°F
2923RPM
N/A
N/A
1.160v
1.599V
1.360v
1.160V
+/-/: Value
F6: Standard Defaults
System
Temperature/
29
F10: Save
ESC: Exit
F7: Optimized Defaults
CPUFAN1
Help Item
F1: General Help
Speed
/SYSFAN1
Advertisement
Table of Contents
