Table of Contents
Advertisement
CONNECTING AND CONFIGURING EXTERNAL EQUIPMENT
5.2 Presentation Interface
Note!
Man_instr_ai71_ai70_r1
The presentation interface consists of two physical ports: PI and
Pilot port. Both ports are functionally equivalent.
The PI port provides a primary port for connecting onboard
equipment such as ECDIS, radar, Long Range AIS etc.
The Pilot port is used for the Pilot Plug included in the
AI71/AI70 systems. This plug is intended for the ship's pilot
equipment, service equipment, etc.
Physical location
Installed on P2, pins 13 - 17. See figure on 55.
Port configuration
The PI and Pilot port have the following default settings:
Baud Rate
38400
The baud rate is configurable to 57600. Refer Configuring
External Serial Ports, pages 72 and 80.
Input sentences
Sentence
VSD
SSD
ABM
BBM
AIR
ACA
ACK
LRF
LRF acknowledgement on PI interface is only available on
software versions later than version 2.00.06.
Parity
Bits
Stop Bit
N
8
Content
Voyage static data
Ship static data
Addressed binary message
Broadcast binary message
AIS interrogation message
AIS channel assignment command
Acknowledgement message
Long range acknowledge
1
63
Advertisement
Table of Contents
