Table of Contents
Advertisement
5
1
2
4
FRONT VIEW
Caution!
Man_instr_ai71_ai70_r1
Bracket Mounting (Option)
When the MKD is bracket mounted (item A100-85), it is not
weatherproof from the back due to a breathing hole in the back
cabinet. When bracket-mounted, the exposed parts of the plugs
should be protected against salt corrosion.
The MKD Cable
The MKD is connected to the AI70 Mobile Unit with a 7-metre
cable included with the system.
The connector may be connected to any of the two inputs on the
rear side of the MKD.
The table below gives the pin layout for the MKD connector and
the 9 pins D-sub connector that is connected to the Mobile Unit.
Signal name
connector
Bus-
Bus+
V System -
V System +
Short circuit on the MKD connector may cause permanent
damage to the AI70 Mobile Unit.
1. Locate the cradle on the mounting site
and mark the 4 holes for the screws on
the mounting surface.
2. Drill the 4 holes and screw the cradle
to the mounting surface.
3. Use the supplied screws to fasten the
MKD to the left and right brackets.
4. Apply the front panel corners.
5. Use the two locking knobs to assemble
the cradle with the left and right
brackets and adjust the MKD for the
best viewing angle.
MKD
Wire colour
1
Brown
2
White
4
Black
5
White
INSTALLATION
D-sub 9-pin
(Mobile Unit)
2
7
1
6
53
Advertisement
Table of Contents
