Specifications; Mounting - Viking E-32T Series Product Manual

Intercom Specifications
Dimensions: 5" x 5" x 2.25" (127 mm x 127 mm x 57 mm)
Shipping Weight: XX lbs (XX kg)
E-32T-IP-SS Faceplate: 14 gauge 316 stainless steel with #4 brushed
finish
Blue LED: Call connected LED lights steady to help locate the button in
low light, flashes during dialing, then lights steady when answered.
Mounting with Rough-In Box (not included): Flush mount to a
standard double gang electrical box (recommended minimum internal
dimensions: 3.65"W x 2.84"H x 2.25"D).
Mounting with Optional VE-5x5: Surface mount to walls, single gang
boxes, double gang boxes, posts, or to a Viking VE-GNP Gooseneck
"Old Work" Double
Gang Rough-In Box*
(Example: Allied Molded 9312
box shown, not included)
(4) Optional Dry Wall
Screws (not included)
Optional VE-5x5
Series Surface
Mount Box
5.14"
2.25"
Optional VE-5x5 Series Surface Mount Box,
not included (DOD 424). Optional VE-LIGHT
kit can be used to illuminate the faceplate
when used with a VE-5x5 (DOD 428).
WARNING: Do NOT use a wet location box.

4 - Specifications

3.65"
*
2.25"
Wide
Deep Min.
Min.
2.84"
Tall Min.
Earth Ground
the Green/Yellow
wire using the
Earth
|
included wire nut
Ground
OR
|
3.25"
5.22"
3.63"
3.63"
(2) Junction Box to
Double Gang Adapter
Plates and (4) 5/64
Hex Drive Flat Head
Screws (included)
pedestal.
Optional Enhanced Weather Protection (EWP) Available: EWP
products are designed to meet IP66 standards and may feature foam
rubber gaskets, sealed connections, gel-filled butt connectors, as well as
potted circuit boards with internally sealed, field-adjustable trim pots and
DIP switches for easy onsite programming. For more information on
EWP, see DOD 859.
Note: When mounting outside to rough or uneven surfaces (ie: brick,
stucco, etc.) apply a bead of clear silicone caulking around the top edge
and sides of faceplate.

5 - Mounting

Peel paper liner and adhere gasket to back of panel,
centering over mounting holes. Caution: For rough surfaces
(ie: brick, stucco, etc.) additional caulking may be required.
0.75"
diameter
knockout
The optional VE-5x5 Series Surface Mount Boxes are designed
to be surface mounted to a single gang box, double gang box, or
VE-GNP Gooseneck Pedestal. For more information on the
VE-5x5 Series and VE-GNP, see DOD 424.
* CAUTION: Excessive wire length and/or using a rough-in box
with inadequate depth can apply force to the circuit board
causing physical damage. Recommended minimum internal
dimensions for rough-in box: 3.65"W x 2.84"H x 2.25"D.
5
E-32T Series
Intercom
(4) T-10 Torx stainless steel, flat head,
security screws and drive bit (included)
(4) 0.38" diameter holes for gooseneck mounting
(2) 0.2 x 0.43 slots for single gang box
(4) 0.2 x 0.43 slots for double gang box
Rear View of
VE-5x5 Series
3.0" 3.3"
Surface Mount Box
3.0"