Viking E-32T Series Product Manual page 13

Setting Description
Enabled/Disabled. When enabled the unit will dial again after a call fails or busy signal is heard.
Redial on Busy
When disabled the unit hangs up after a failed/rejected call.
This setting determines how the LED on the E-32T-SS-IP will act when idle and during calls.
LED Mode
Entry Phone
Emergency Phone
LED Mode
Emergency Phone
Outbound Only
Off
When the SIP/Network Alarm is active (unit is not registered, or a network error) the
Alarm Mute
E-32T-SS-IP will beep 3 times every 30 seconds. The LED on the button will also flash. When
Alarm Mute is set to enabled, the LED will still flash but no beeps are produced for the Alarm.
Description
The LED will remain ON in the idle state, turn off while button is
pressed, blink during dialing, light steady when the call is answered,
then turn OFF momentarily when the call is completed.
The LED will remain OFF in the idle state, blink during dialing, light
steady when the call is connected, then turn OFF when the call is
completed.
On outbound calls, the LED will remain OFF in the idle state, blink
during dialing, light steady when the call is connected, then turn OFF
when the call is completed. On inbound calls, the LED will remain off.
This is useful for silent monitoring on inbound calls.
Stays off when idle and during connected calls. Flashes on boot up,
during dialing, and when the unit has a Network/Registration error.
13
Factory Default
Enabled
Entry Phone
Disabled