Table of Contents
Advertisement
Test Email:
Click the Send Email button to try a test email using the saved settings (you must apply changes before testing).
The Primary SMTP account will be tested first, if it fails the Secondary account will be tested.
Notification Types:
Check the button for any events you would like to send emails for. The body of the email will include a description of the
event type.
Notification Type
System Startup
Scheduled Test Call
Inbound Call
Outbound call
SIP / Network Alarm On
REX Input Closure
Info Button Closure
MIC / Speaker Failure
Camera Failure
PIC Comm. Failure
Event Type
An email will be sent when the device is power cycled, rebooted, or after a firmware upgrade.
When the Test Call is set up (see Reverse Polling) an email at the same time as the Test Call is
scheduled for.
An email will be sent when a SIP call is sent to the X-Series device. This is sent regardless of the
Inbound Call Mode.
An email will be sent when a SIP call is made with the Call button.
When the SIP/Network Alarm activates, and email is sent. This occurs when SIP registration is lost, or
the network becomes unreachable (email is sent when network returns indicating the error occurred).
An Email is sent when the relay activates from a closure of the REX Input (green wire pair).
An Email is sent when a SIP call is triggered by the Info button (model specific).
When the MIC/Speaker Diagnostic fails an email is sent.
If the camera module fails an email is sent.
An email is sent if there is a major hardware issue on the device.
20
Advertisement
Table of Contents
