Table of Contents
Advertisement
Configure Tab
Phone Settings
Speed dial numbers, call/dialing
options and volume levels are set on
the Phone Settings Tab. These settings
are used to control how the device acts
during inbound and outbound SIP calls.
Setting
Description
These are the phone numbers/extensions the E-32T-SS-IP will dial after pressing the
Speed Dial Numbers
Call button. The numbers are dialed top to bottom in order, once a call is answered
the dialing sequence is ended.
1-6 digits. This code must be entered by a caller before the relay can be controlled.
This only applies to calls inbound to the E-32T-SS-IP. A long access code makes the
unit more secure, but keep in mind it will likely be manually dialed by a caller from
Access Code
their SIP device.
Note: In-band DTMF detection is not supported at this time.
Disabled: All inbound calls are rejected. Auto Answer: Inbound calls are auto
answered with video and audio. Relays can be controlled after the Acess Code is
entered (if programmed). Auto Answer Secured: Inbound calls are auto answered
Inbound Call Mode
without video or audio. The caller has 10 seconds to dial the Access Code to
establish video and audio or the call will be ended. Relays can be controlled after the
Access Code is entered (if programmed to Door Strike Mode).
Affects outbound calls made by the E-32T-SS-IP. Set to 0 to disable the timer.
Call Time
Resolution is in seconds, 1-999.
Affects inbound ringing calls made to the E-32T-SS-IP. Set to 0 to disable the timer.
Inbound Call Time
Resolution is in seconds, 1-999.
This value is how many seconds the E-32T-SS-IP will try to call the "Numbers". Once a call is
Ring Timeout
answered this timer stops and the Call timer is in control. This only affects outbound calls from
the E-32T-SS-IP.
Ring Volume
Changes the volume of Loud Ringing.
Speaker Volume
0-9. Changes the level of the audio produced by the E-32T-SS-IP speaker.
Mic Volume
0-9. Changes the level of the audio from the E-32T-SS-IP microphone.
Enabled/Disabled. Set this to enable when the E-32T-SS-IP is calling outside of the
Use Call Progress
building and analog audio detection is required.
The number of times the group of programmed numbers is dialed. 0 = continuous
Lap Counter
dialing. Example: 5 numbers are programmed, Lap Counter is set to 3. The unit will
dial 15 times (3 laps of 5 numbers).
12
Factory Default
n/a
123456
Auto Answer
180 (3 minutes)
180 (3 minutes)
30
6
3
5
Disabled
7
Advertisement
Table of Contents
